Ask Experts Questions for FREE Help !
Ask
    zues's Avatar
    zues Posts: 14, Reputation: 1
    New Member
    		  
    #1

    Sep 29, 2007, 10:11 PM
    90 toyota 4x4 pickup
    I am about to buy a 90 toyota pickup and I was checking the four wheel drive to make sure it worked. I got out to lock in the hubs and I found that they where already locked in. I then put it in four wheel drive and it worked. So I then went to unlock them and the drivers unlocked but the passenger side hub would only turn to about a quarter turn from the release arrow. My question is, is that bad and if so what might be the problem. I also wanted to know is it bad to just leave them in the locked position all the time.
    kitch428's Avatar
    kitch428 Posts: 1,440, Reputation: 152
    Ultra Member
    		  
    #2

    Sep 30, 2007, 06:53 AM
    They should be in free position. The one that turns 1/4 will need to be removed and re positioned or indexed on the hub until it will rotate the full half turn.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1984 Toyota pickup won't start [ 3 Answers ]

MY vehicle was running fine until one wire that was leading to my stereo burned up. As I don't know what this has to do with my starter, what could the problem be. The engine sounds like it wants to turn over, but isn't actually starting.

Overdrive on a 1988 Toyota R22e pickup carrying a Winnebago not work above 4000 [ 2 Answers ]

The overdrive on a 1988 Toyota R22e pickup carrying a Winnebago does not work above 4000 feet altitude, according to the owners manual and my experience. How can I modify the pickup automatic transmission overdrive so that it works above 4000 feet altitude? On long flat roads above 4000 feet, I...

87 Toyota 4x4 bad timing belt? [ 2 Answers ]

My toyota 22R truck would not restart after being driven for about 20 minutes in the city. I actually turned the truck off, restarted it and it died with a loud cluck noise after about 30 seconds. The starter turns the engine fast enough but when I checked TDC the timing marks lined up but the...

73 Dodge 3/4ton 4X4 Truck [ 2 Answers ]

Starter solenoid keeps going out-overheats and quits working. Know this means too much voltage to the solenoid, what needs adjusted/replaced now? Have replaced voltage regulator, plug wires, battery, rotor & points. Help

View more questions Search