Ask Experts Questions for FREE Help !
Ask
    Neil Skelton's Avatar
    Neil Skelton Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 13, 2007, 08:09 AM
    Bathroom wiring
    I am wiring an elecric towel rail & blanket underfloor heating in a bathroom, I know this has to be done to IEE standards trough a flex outlet & an external fused connection unit. I just looking for conformation on what height I should put the flex out let in the bathroom.
    I am in Scotland, I believe I can fit it at 350mm?
    Neil
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Aug 13, 2007, 02:33 PM
    Only the manufacturer will provide that information, it would not be a reg issue. Check the installation instructions, or if very critical contact the manufacturer to learn of the specs.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bathroom wiring diagram [ 8 Answers ]

I am wiring a new basement bathroom. I have created a diagram showing how I plan to wire it. Just curious if anyone sees any problems with the way I'm doing this? Thanks and hope the attachment shows up correctly!

Bathroom Wiring [ 1 Answers ]

I have read as many bathroom posts as I could find but still have a specific question. First I want to reiterate what I have gathered. Please verify the following for correctness. 1. Outlets and lights must be on separate circuits in a bathroom. 2. All outlets must be GFI protected by breaker...

Need help wiring a bathroom? [ 6 Answers ]

I am installing a new bathroom in my basement and have a few questions. First a little information on the circuits. The bathroom will have 2 circuits. Circuit-1 = (2) GFCI's one on each side of vanity top. No lights, switches or appliances on this circuit. Circuit is dedicated only to the...

Bathroom wiring [ 2 Answers ]

First question was answered somewhat,here's the scenario,remodeling bathroom,ran 20 amp service,wired in fan/light .light is wired for use by itself.Fan,light in tub,shower,vanity light and three outlets [one outlet is gfci,20 amp rating. Would like to use 15 amp switch for general light,this is in...

Bathroom Wiring [ 7 Answers ]

I am in the process of putting in a full bath and had a question regarding the wiring. I ran a #12 and #14 from the breaker and intended on using the #14 for the bath fan/lights and the #12 for the GFI outlet. I want to also run the 12 gauge from this GFI to one I intend to install in the...

View more questions Search