 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Wiring Rheem motor
I just bought a new replacement motor and capacitor for my Rheem RPKA-043JAZ 3.5 ton outside unit. My question is about he wiring. My old motor had 3 wires - orange, brown and black. This motor has five wires. Do I need to hook up the other two wire - purple and yellow? The motor is an Emerson 51-23055-11
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I just replaced the condenser fan motor and it initially spun up then stopped, after 10 minutes it ran again then stopped. Now I can hear it buzz then stop but not spin. The original motor was a GE 5KCP39BG K075CS 1/6 HP 1075 RPM 208/230 V its replacement a Dayton 4M205G 1/4 hp 1075 RPM ...
:mad: Perhaps someone here can help me, I bought a small GE 120v electric motor for a replacement for a machine. It has 3 three wires (red, yellow,blue) and requires a 10mf capacitor. My best guess was to wire it with Blue to line , red-line & cap, and yellow on the other cap term. But it runs very...
I am trying to hook up a Honeywell RTH 7400 Tstat to the existing Rheem HVAC in my house. Currently using Rheem thermostat that came with the house (non-programmeable, using mercury tubes). Heating is provided by a heat pump as well as Natural gas furnace for aux heating (besides the air...
The motor looks to have 2 orange wires, 1 black wire, and 1 brown wire. Where do they go back to. Do the 2 orange wires go to the capacitor? Black go to contact + and brown to common? The 2 orange wires have continuity between them with no or little resistance. Are these both ground wires or...
We have a Rheem gas furnace/central AC system. The blower motor went out. We finally found a new one. However... I was stupid and did not draw the wiring diagram when I disconnected the old one. Now I can't seem to figure out how to rewire everything. There is a relay switch on the side...
View more questions Search
|
