Ask Experts Questions for FREE Help !
Ask
    chuckb56's Avatar
    chuckb56 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 15, 2007, 09:12 AM
    Kenmore Elite Catalyst Not Running
    Machine fills with water then makes a little clunk type sound and then nothing. Emptied out several times and still no motor activity just the little clunck/click noise. From previous post I am guessing the coupler? Is broken. I cannot find model number under lid. Only this on decal SM9711035. The panel did read out F-4. Need disassembly advice and where to get part.
    Thanks.
    Chuck
    kline001's Avatar
    kline001 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Jun 26, 2007, 04:30 AM
    Quote Originally Posted by chuckb56
    Machine fills with water then makes a little clunk type sound and then nothing. Emptied out several times and still no motor activity just the little clunck/click noise. From previous post I am guessing the coupler?? is broken. I cannot find model number under lid. Only this on decal SM9711035. The panel did read out F-4. Need disassembly advice and where to get part.
    Thanks.
    Chuck
    Get a new washer, I have had this repaired twice and it is out again
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #3

    Jun 26, 2007, 04:58 AM
    The coupler is between the motor and trans. You will need to remove the motor to replace it.. You will have to go through the back of unit to get to it. Take the back off unit and take a look inside. If it's something you think you can tackle and need help, post back. Not too difficult. If not real handy call a tech.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore elite catalyst washer not spinning [ 1 Answers ]

Model number 11020072991 Ok, here's where I'm at. I believe it's the drive coupler? I've disconnected the control panel and fliped it back. I remove the brass colored springs holding on the cover and removed the cover after disconnecting the clamps and hoses needed. Now, I'm stuck and don't...

Kenmore elite catalyst washing machine [ 1 Answers ]

Machine won't work; I am receiving a F 4 and/or F3 message - what does this mean?

Kenmore Elite Catalyst [ 1 Answers ]

My washer is leaking while it is agitating. Any ideas?

Kenmore Elite Catalyst Washer [ 1 Answers ]

My Kenmore Elite Catalyst Washer with digital display was not spinning. I replaced the coupler, the old one was worn. The washer did spin however it made a whinning noise. I ran several loads and now it will not spin again. Any suggestions on what the problem may be? Thanks.

View more questions Search