Ask Experts Questions for FREE Help !
Ask
    topdog1's Avatar
    topdog1 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 25, 2007, 10:16 PM
    Craftsman weedeater
    My craftsman is a little hard to start, but when it does I give it fuel it stops what could be wrong and is it something that I can fix.
    bedorr's Avatar
    bedorr Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Jun 25, 2007, 10:32 PM
    Quote Originally Posted by topdog1
    My craftsman is a little hard to start, but when it does i give it fuel it stops what could be wrong and is it something that i can fix.
    When you start it will it accelerate with the choke partially closed? If so it sounds like you need to make an adjustment of about 1/2 turn counter clockwise on the low speed jet. I have repaired several brand new string trimmers with the same symptoms. They would barely idle and when you open the throttle they die.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman Weedeater won't stay running [ 5 Answers ]

I have a convertible craftsman weedeater that has run like a champ - until now! I can get it to run briefly, a few minutes at most, then it dies and will not restart. After reading some similar posts I am beginning to suspect either an in tank filter or the inlet filter on the card Sound...

Restringing a Craftsman Weedeater [ 1 Answers ]

Hello, I have a Craftsman weedeater Mod. # 358791540 and I can not figure out how to put new string onto the spool. Any help would be appreciated, thanks in advance.

Craftsman weedeater carb [ 2 Answers ]

I need to know how to set the adjustments screws on the carborator of a walbro carb-Modle#wt298.How far to turn each screw.

Craftsman Weedeater Starter Rope Replacement [ 2 Answers ]

I'm trying to replace the starter rope on my Craftsman Weedeater. Can you tell me how to remove the clutch assembly from the shaft?

View more questions Search