[300c]

Need to find and replace starter on honda accord 1998 lx what tool are needed and do I need to take any parts off

[TxGreaseMonkey]

Honda Accord Starter Replacement

1. Disconnect the negative battery cable.
2. Disconnect the starter cable from the "B" terminal on the solenoid, then the BLK/WHT wire from the "S" terminal.
3. Remove the two 14 mm bolts holding the starter, using a 3/8" drive ratchet wrench attached to a 6" extension bar; then, remove the starter.
4. Install in the reverse order of removal.

NOTE: When installing the starter cable, ensure the crimped side of the ring terminal is facing out. It's a good idea to clean both terminals and connectors with #240 abrasive cloth and coat with dielectric grease.

It's located just below and to the rear of the distributor (on top of the transaxle).

[Stratmando]

Great advice, Can follow big positive wire, Have found majority of Starters on same side as battery.

[rondom1]

Of most cars honda starters are generally easy and sit on the top of the tranny, so if you know what you are doing it should be maybe a 30 - 45 min job (if you've done it before like me otherwise I don't know how long you'll take)

[jay93]

Exactly what I need