Ask Experts Questions for FREE Help !
Ask
    dixonjk's Avatar
    dixonjk Posts: 4, Reputation: 1
    New Member
     
    #1

    Jun 6, 2007, 06:42 AM
    Running a line with the heatpump lineset
    I have a 3" PVC pipe with the heatpump lineset and thermostat wire in it. I want to know if it would be OK to run a electrical wire through this pipe to add a line to a tankless water heater?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Jun 6, 2007, 07:00 AM
    Not sure why you'd want to do this. You'll need a 220 cable which can be purchased fully insulated. If you want to see a flurry of response just start asking, in the plumbing forum, the pros and cons of a tankless water heater.
    dixonjk's Avatar
    dixonjk Posts: 4, Reputation: 1
    New Member
     
    #3

    Jun 6, 2007, 08:11 AM
    Quote Originally Posted by dixonjk
    I have a 3" PVC pipe with the heatpump lineset and thermostat wire in it. I want to know if it woudl be ok to run a electrical wire through this pipe to add a line to a tankless water heater?
    I want to do this because its not practical to run a new wire through the wall or ceiling. I want a tankless heater to give me more shop space!
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #4

    Jun 6, 2007, 02:26 PM
    Is this PVC just a chase in the wall to allow the passage of the copper lines? If so you should not put your 220 in the same chase. Those copper lines vibrate and if it caused a breach in the 220 insulation you will get a mineral oil fire and a dead short.
    dixonjk's Avatar
    dixonjk Posts: 4, Reputation: 1
    New Member
     
    #5

    Jun 6, 2007, 02:41 PM
    Quote Originally Posted by dixonjk
    I have a 3" PVC pipe with the heatpump lineset and thermostat wire in it. I want to know if it woudl be ok to run a electrical wire through this pipe to add a line to a tankless water heater?
    Its about a 25 ft span
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
     
    #6

    Jun 6, 2007, 03:46 PM
    All cables in one raceway need to be rated for the highest voltage that will be in that raceway. So the thermostat cable will need to be rated for at least 250 volts.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Running a new gas line to a dryer [ 1 Answers ]

We are moving to a new home today. The previous owner did not have a gas line for their dryer. I am pretty sure I can run the line but want to be sure I am not overlooking anything and can learn key tips and warnings (safety and otherwise) before starting(e.g- choosing the diameter of the gas...

Installing heatpump or AC [ 5 Answers ]

Hi I'm remodeling a house built in '32, with an addition in the 40s or 50s. The house is about 1200sq ft (800 sq ft w 9' ceilings, 400 sq ft with 8'ft ceilings) with a 1/2 basement where the heater (oil) water heater, circuit panel etc. At present there is no AC in this house, although the air...

Bath tub shower spout & head running water running at same time [ 1 Answers ]

I started with a slight dripping problem(sayko system).i decided to replace all 3 stem assemblies together as they all were about 18 years old.after reassembling the new stems(danko brand),turned on the water supply & checked faucets.hot & cold worked fine but when the shower was turned on,water...

Heatpump thermostat [ 1 Answers ]

I have a goodman heatpump with a janitrol 1890 thermostat it has never switched the aux heat on .When the temp gets too cold for heat pump to make heat .I have to turn emergency heat on myself .Book says model1860 thermostat is what should be installed is this my problem if so a new thermostat...

Runaway heatpump [ 5 Answers ]

I have a 1400sq foot 2 story home built in 2005 with a single heat pump. The thermostat is located on the first floor. During the winter the heat will run and run to try to maintain the temperature on the first floor but the second floor will bake. For example, the first floor may be set to 70 but...


View more questions Search