 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Just my initial idea based upon the information that you have given would be, if there is a shut-off valve under the sink for the hot water, then I would try tapping on it with something like a hammer. Turn the valve to try to loosen anything that might be stuck in there. Sometimes debris can get built up in those valves. I have tried this method and had success with it.
Maybe someone else on this site will have a better idea, though. |
||||
|
||||
|
Sounds like you have mineral buildup in your water heater and now its got sucked into your faucet. Shut the water off to the faucet in question and open it up. Check and clean the inlet ports on the cartridge or seat and turn the water back on for a moment to flush out any crud remaining in the supplies. To prevent this from happening again flush your water heater. Let me show you how.
For long life and fewer troubles you should keep your heater clear of mineral build-up by flushing on a regular schedule. Attach a hose to the boiler drain at the bottom of the tank. With the pressure on, open the boiler drain and let it run until the water runs clear. You will see a spurt of red,(rust) followed by white or yellow grains,(lime or calcium carbonate). This shouldn't take more then a few minutes. Do this monthly to keep it clear. Now flush out your hot water lines on ALL fixtures that are affected . Now pull each aerator and clean the screens. Be sure you put them back togather the same way you took them out. Don't forget to flush it out every month. Your heater will thank you for it. Hope this helps, Tom |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
The lever to switch from water out of the shower head to out of the big tap has come away. The lever looks like it should be screwed in, but it won't go. Any ideas how to put it back together please?
I have a mixer tap in the kitchen. The hot tap works fine, however the cold tap has a burst of pressure then falls off after a second, If you keep turning the tap further and further on the water comes out at a high pressure. Is the problem with the washer or is it another part of the cold tap?
I have recently changed the bath and taps in my bathroom from a pair of taps to single mixer taps. Since doing this I noticed that the hot water only trickles out, the cold water is very powerful, so to fill up a nice warm bath it would take at least an hour and by then the hot water would have...
Hi There, I Was Wondering If Anyone Know's How To Fix The Bathroom Mixer Tap. When You Turn It On, ( the hot water tap on the bath ) It Only Turns A Small Amount And The Water Comes Out Ever So Slow.. It HAS Been Doing That For A While now, But Now It Is gettind Bad. Its Very Slow. Can Anyone...
Hello, I have removed a washbasin with separate hot and cold water taps from an ensuite bathroom in my mother-in-law's bungalow and fitted a new basin with a mixer tap. When I connected everything up and tried the tap I got hot water but no cold. However, the cold water supply pipe got warm...
View more questions Search
|
