Ask Experts Questions for FREE Help !
Ask
    DIYKEVIN's Avatar
    DIYKEVIN Posts: 2, Reputation: 1
    New Member
     
    #1

    May 31, 2007, 01:25 AM
    Shower drain trouble
    I have a duplex and the upstairs shower has just started leaking. It's the drain pipe and seems to be after the drain bath. To replace the pipe I would have to rip up the flooring of the shower and this would be costly. So my question is, can I use some form of glue or epoxy or something on the inside of the pipe to fill the crack - let dry and fix my problem. The crack is on the bottem of the pipe cause even a small amount of water causes the leak. I don't believe the crack is bad as large amount of water still produce the same amount of leaking water.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Jun 1, 2007, 01:55 PM
    Good news/ bad news. You won't have to rip up the flooring, you will have to open the ceiling from below. The drywall is easy to patch compared to the flooring. Your drywall is probably already getting wet and must be replaced. No cement or epoxy inside the pipe. The leak is usually not the pipe but could be a fitting. Do you know if its PVC or galvanized?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #3

    Jun 2, 2007, 11:20 AM
    Bals last question would have been my first. If you can't open it up to look then how do you know it's a crack on the bottom of the pipe? Regards, Tom
    DIYKEVIN's Avatar
    DIYKEVIN Posts: 2, Reputation: 1
    New Member
     
    #4

    Jun 3, 2007, 11:23 PM
    Howzit

    Firstly no dry wall Duplex entirely made of brick and concrete. Can't go through flooring - concrete slabs... I had to rip up tiles in the end and replace PVC pipes. Concrete flooring had shifted it would seem and cracked PVC pipe alone with it. Problem solved, thanks anyway

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Installing Basement Shower Drain with Washing Machine Drain [ 5 Answers ]

Hi folks: I would like to install a shower that drains into the same drain as my washing machine. Right now the washing machine drain, 1-1/2" ABS, comes in horizontally about 12" above the concrete floor into a 1-1/2" Tee on a vertical pipe. From this Tee, the vent goes straight up to the...

Shower weep hole drain turned into tub drain [ 1 Answers ]

I am remodeling my shower to a roman tub. The existing drain is a weep hole drain. Is there a plug for these type of drains? The idea is to use the same drain system and hot mop, tile, etc. around it.

Trouble w/ my floor drain [ 3 Answers ]

Well, I have been having an issue w/ my floor drain in my laundry room. About a year ago my drain started to back up when ever my washer drained, not badly though. The water would just come up about an inch past the drain hole. Now as time has gone by, if I don't keep an eye on it, it floods my...

Trouble Shooting Floor Drain backups [ 1 Answers ]

I am employeed by a company that offers a service to clear blockages in commercial floor drains; especially restaurants and grocery stores where grease is prevalent. We do use power snakes at times, but more often we use high pressure water. Our technicians struggle a lot at troubleshooting the...

Converting cast iron floor drain to shower drain [ 3 Answers ]

I am adding a bathroom to my basement, which has partial (complete? ) plumbing already roughed into the floor (in 1976). Sewage lift station (vented) is 3 ft from 4" styrofoam plug (toilet), 4 ft from 1 1/2 inch cast male pipe end extending through floor (lav, have already added vertical vent...


View more questions Search