Ask Experts Questions for FREE Help !
Ask
    Ford bronco's Avatar
    Ford bronco Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 10, 2016, 08:03 PM
    Offset flange sets to high and commode won't took floor by couple of inches
    Installing new commode and was using an offset flange but it sets to high to install commode. Is there a low profile flange that is same hight as standard flange?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Mar 10, 2016, 08:14 PM
    You will need to cut the old pipe lower to install the offset type.
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #3

    Mar 11, 2016, 03:10 AM
    What happened to the old flange ? Was it off-set flange, too ? Old commode fit OK and new one won't ?

    There may be another solution to this. Post few photos from the installation showing pipe and old flange. Thank you

    Milo

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Repair an offset toilet flange in slab floor [ 1 Answers ]

I have a old rental and the old toilet flange is an offset flange and all the bolts and flange is rusted out. Is there a way to replace the flange to get new closet bolts in with out cutting the concrete up?

How high should the flange on a toilet be from the floor? [ 4 Answers ]

I placed wonder board on the floor the flange for the toilet is about 1/2 above the floor tile is this too high and what would be the hight of the flange normally

How high should a toilet flange be off the floor? [ 10 Answers ]

I just bought a forclosed house. In the master bath I have a Mansfield 160 toilet that rocks and is leaking water when flushes. When the toilet is level, NO part of the toilet touchs the floor... It basically balances on the flange. I tried the little spacers that you can get at Home Depot /...

Commode floor flange [ 2 Answers ]

R & R commodes several times and already know all the tricks and pitfalls, but today I hit a new one. When I took up the commode to see why it rocks, the floor flange came too!! The floor is concrete, the closet bend seems to have a flair on the end, and the brass (?) flange is warped. I have no...


View more questions Search