Ask Experts Questions for FREE Help !
Ask
    rsack57's Avatar
    rsack57 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 12, 2016, 08:47 AM
    Bryant pulse 90 furnace runs, lights, no high heat
    The unit started with a 33 code. I resolved that issue but not the furnace runs constantly and will only heat up to 67 degrees in the house. All appears to be working when I look at the furnace. Flame is on and blower is running. The furnace does not cycle so it is not over heating. Air from heat ducts is warm but not hot enough.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Jan 12, 2016, 02:23 PM
    33 on many units is the pressure switch. Since the unit appears to be working, I would check for a disconnected duct, insulation off the ductwork or something similar. I just made a service call and found that rodents had torn off and chewed open 5 ft. of ductwork in the attic. Depending on ambient temps, high wind chills, leaky windows, poor insulation etc, you may have reached the output capacity, particularly in an older house.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant furnace, Blower runs, no heat, won't fire... [ 0 Answers ]

Bryant furnace. Model # 395cav048090abja Series B Fan constantly running. Won't turn off unless power turned off at furnace. Won't fire. No heat. Does anyone know what this could be? It's getting cold in here ! Thanks

I have a Bryant 355AVV Furnace I want high-heat instead of low heat, what switches? [ 0 Answers ]

I have a Bryant Gas Furnace Model 355AVV. It usually runs on low-stage heating if I have the temperature set to 74 degrees F. When it gets colder it doesn't seem to go to high-stage heating very often unless we turn up the thermostat to a much higher setting. It's like it isn't aware that the...

Lennox pulse furnace cycle fan runs [ 1 Answers ]

My lennox pulse is not keeping my house warm enough, sounds like the fan runs constantly and can hear the furnace kick on for a few seconds at a time. What's the problem. BTW its -30* F this morning

Bryant gas furnace runs blows no heat [ 1 Answers ]

Furnace is running, but no heat is blowing into our house. It smells like a candle that has just been put out. The vent pipe that goes to the chimney is hot to the touch. What do I need to do?

Bryant gas furnace runs blows no heat [ 1 Answers ]

Furnace is running, but no heat is blowing into our house. It smells like a candle that has just been put out. The vent pipe that goes to the chimney is hot to the touch. What do I need to do? Ok, this started this morning. It seemed cold in the house, turned up the furnace and it didn't make...


View more questions Search