Ask Experts Questions for FREE Help !
Ask
    stevencsutton's Avatar
    stevencsutton Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 30, 2015, 06:18 PM
    Mixet shower
    I have a mixet shower/tub that has little water flow compared to the other bathroom. Changed the mixer still the same issue of low water flow
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Nov 30, 2015, 08:04 PM
    Are both hot and cold equally slow?
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #3

    Dec 1, 2015, 07:57 PM
    Make sure you have both handles adjusted so they give you good water flow. Also, some Mixet valves have "stop valves" on the rough body. Make sure both are fully open - and if they have filter screens - that those screens are clean of debris

    Back to you

    Milo
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Mixet shower valve installation [ 7 Answers ]

Hello, I replaced the mixet 4 1/2" stem valve ,Its not wanting to work properly and in the instructions it says the "red dot" goes "up".. The replacement kit I got from home depot didn't have a red dot to be found or a small chennel in the brass. Any ideas on how to go about making sure the stem is...

Mixet shower problem? [ 0 Answers ]

Our bathroom uses a mixet shower handle/cartridge but its leaking water so I bought a new one but unfortunately even with the new cartridge the leak still continues even I tighten so so hard what do you think is the problem?

Diagram on how to change a Mixet shower faucet [ 3 Answers ]

How to completely change a Mixet shower faucet

Removing mixet shower valve stem [ 0 Answers ]

Hi, The Mixet valve in my shower stall needs replacement since turning the temperature control handle is very difficult. The valve stem will not pull out using max force with channel pliers (padded), I can turn the brass screw adjustor and out comes the front part but that leaves the rear...

Mixet shower handle/cartridge [ 3 Answers ]

I recently had a leak in my shower and replaced the Mixet cartridge which seemingly fixed the problem, but now the dial/handle seems unresponsive and isn't opening or shutting the valve. I can open it and close it by turning the handle screw with a screw driver, but that doesn't seem like a good...

View more questions Search