Ask Experts Questions for FREE Help !
Ask
    Cyclone16's Avatar
    Cyclone16 Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 14, 2015, 09:36 PM
    Wiring up 3 speed furnace blower motor where to put wires.
    Hello all,
    I got a protect blower motor with two brown wires,I know the brown wires go to capacitor but where do I put the other wires to. One red,one white, one black, one blue. It is connecting to a rheem furnace on the board I got a m1, cool ,heat , neutral.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Sep 15, 2015, 07:35 AM
    You will need to look at the wiring diagram which should be on the air handler. There is no code for most wire colors. Typically black, blue, red and purple are current carrying, green, green/white are grounds, white is neutral. Is "protect" a brand? Look on the endplate. My guess is the colors would be different speeds and possibly rotation.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do I properly install a inside furnace blower motor that has 6 wires instead of 7 [ 0 Answers ]

The blown motor had 2 brown wires(one with a white stripe),a red, a blue, a black, an orange, and a white wire. The new motor, Century DL 1056, has 1 brown wire with a stripe, 1 red, 1 blue, 1 black, 1 orange, and 1 yellow wire coming out of the motor(plus 2 sets of short wires connected to each...

Furnace blower motor stops at high speed when A/C kicks in [ 0 Answers ]

I have an Armstrong furnace. The main blower stops and buzzes when the A/C kicks in. The blower fan attempts to spin at a higher speed when the A/C starts but instead locks up. Is this a problem with the blower or with related circuit board?

Electric furnace blower motor not changing speed? [ 0 Answers ]

Just replaced motor but the fan is not turning fast enough to push air through system?

Wiring a 2 speed blower motor [ 1 Answers ]

I scavenged a working motor from our old furnace a/c unit and recently installed it (and ductwork) in my basement to draw excess hot air from around our fireplace insert on the main level. Unfortunately the motor only seems to be blowing in the a/c mode which is much too fast even for pulling hot...

Can blower motor speed be adjusted on a Day and Night furnace ? [ 1 Answers ]

I have a Day and Night up flow furnace, about 13 years old. Can the blower motor speed be adjusted to a slower speed ? There is only 8 feet of duct and the noise coming out of the registers is very loud. Model # 395CAV036055 66,000 BTU Blower # 511, 1/3 hp If no one has any info, does...


View more questions Search