Ask Experts Questions for FREE Help !
Ask
    J DEAN's Avatar
    J DEAN Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 30, 2015, 05:11 PM
    Just installed new pfister f-529-7sls no pressure on cold side pressure at valve
    Cannot get any water pressure out of cold side of newly install sink faucet it is a single handle faucet
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    May 31, 2015, 09:34 AM
    If it is only the cold side it could be debris knocked loose during install. Double check the valve on the supply side and get back to us. Make sure that valve is fully opened
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kohler K-304-K valve has plenty of cold water pressure, but no hot water pressure [ 1 Answers ]

So I just installed a K-304-k into a house. The house has been vacant for about 15 months now, so no one has been using the water. I came in and replaced the valve, and closed up the wall. I installed all the fixtures, and sure enough, no hot water. It comes out in a slow trickle. Here are...

Pressure relief valve cold side? [ 0 Answers ]

A home inspector has recomende one to be installed on a home that was built in 1987 that is on city water.

Cold water pressure relief valve leaking, not the TRP valve [ 5 Answers ]

Hello. Cold water pressure relief valve start to drip water through the drain pipe. I replaced it with a new one but it is also dripping water. I have reduced water pressure in the house to the minimum by turning main water supply valve but it still leaking. Thanks for your help.

Just installed a Pressure reducing valve.. now have spiking psi from 60 to 150psi! [ 0 Answers ]

Hi Folks, Will an expansion tank be able to absorb a 90psi pressure difference? I have 2 50 gal WH's and the static pressure is 60psi, but spikes to 150psi when both are firing. The pressure subsides about 10psi per 15 minutes, or if when the I relieve it using a cold faucet in about 4...

Can I solder outlet side of a ball valve if the valve is closed and under pressure? [ 0 Answers ]

Can I solder outlet side of a ball valve if the valve is closed and under pressure?

View more questions Search