 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Plumbing Bowl won't fill up
Water not filling in toilet. Can be flushed once and then have to wait for it to fill to its very small level. Tank seems full. Also in the same bathroom used drano 3 times. Clears for a few days and clogs up again. What can be wrong??
|
||||
|
||||
|
First remove the tank lid and make sure that the refill tube, that little black tube from the fill valve to the overflow pipe, is pointed into the overflow pipe.
If so flush the toilet and make sure that there is a good stream of water from the refill tube into the overflow pipe. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
The toilet works,tank fills and it flushes,but the bowl gets no water?what is up with this?
I have a 5hp B&S with a pulsa-jet carb (fixed jet). If I take carb off the fuel tank and manually fill reserve bowl, engine runs just fine for roughly 2 min then quits (reserve bowl is empty). The fuel pump diaphragm is wet when disassembled and looks brand new. I was given the rototiller with...
The toilet bowl in the main bathroom will not hold water. The tank seems to be fine. When I flush it, the water fills in the tank and in the bowl, but after the tank fills the bowl drains until there is only about a cup of water left. I don't see a leak anywhere... Does the toilet need to be...
I've read through most of the questions but don't see this exact question. One of the toilets in the house doesn't fill enough - the bowl only fills about 1/2 of what it should. The other toilet is fine. I mention the other toilet because 'as the crow flies' they are in proximity. I think they...
I have an older toilet and recently the toilet bowl fills to only about half of what it used to. The tank fills properly and the fill tube is inserted into the overflow tube. By pushing down on the float for a few seconds I can keep the water running and fill the bowl. The level of the water in...
View more questions Search
|
