 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Craftsman snow king 5.5 hp. When pulling the cord, it just stops
When I pull the cord, it pulls out 3/4 of the way and stops dead like it gets jammed. I have pulled the cord off and found nothing jammed. Both stages turn freely, but the engine never catches.
|
||||
Check out some similar questions!
Tecumseh Snow King LH318SA on a Craftsman snowblower. To get this motor to start in colder temperatures I have to use the electric start and while the motor is turning, push down the primer bulb. As soon as I touch the primer bulb it starts no problem. If I prime it ahead of time, then use the...
Engine stopped after running out of gas. Refueled... attempted to start engine using the pull cord... there was no resistance at all... cord is intact... possible failure points are? Any options other than the shear pin? Any idea on cost of repairs...
My cord to the recoil starter on my snowblower broke at the base. I have unbolted the starter from the engine and brought it inside. It is looking like I have to take apart the unit just to push the cord into its slot as there is very little finger room to work with. The starter is on an 11...
Has a new auger belt. Only throws it about 5 feet. Constantly gets clogged.
How to tighten auger belt on murray 8 hp snoe king
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
