Ask Experts Questions for FREE Help !
Ask
    TuckerMtn's Avatar
    TuckerMtn Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 16, 2014, 12:35 PM
    How to install a pressure control switch on 1 1/2 hp utilitech irrigation pump
    I just replaced my shallow well pump. The 1 1/2 hp Utilitech irregation pump will not turn off. It appears not to have a pressure control switch!
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Dec 16, 2014, 02:50 PM
    That is an irrigation pump, not a house supply pump. Do you have a current system with a switch and tank?
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #3

    Dec 16, 2014, 06:31 PM
    Assuming the system has a pressure tank, then you can install a switch. Does it have a tank?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do you adjust the pressure switch on a Utilitech 3/4hp Jet Pump? [ 6 Answers ]

I think I messed up the standard adjustment of the Utilitech Pump which is set at 20/40 from the factory. Now I can't get the pump to stay on since I adjusted it? Curious if anyone knew any tricks?

Well pump pressure control switch placement [ 3 Answers ]

I have a drilled well. The expansion tank and pump controls and whole house canister filter are all down in the crawlspace. A space that as I get older, I like to visit less and less. I want to move the whole house filter, the pressure control switch and the pressure gauge up into a room on the...

Testing pressure control switch on submersible pump [ 0 Answers ]

Testing the pressure control switch I found that the ground had 1/2 volt. Just wondering why that would be?

How to wire pressure control switch for a well pump [ 3 Answers ]

Ok, I am pulling my hair out. I changed my pressure control switch(square D). Because my pump wouldn't kick back on after getting below 30#. (I have a 30-50) It was 15 years old and I have very hard water so I figure it was time. Still the same result pump cuts off at 50 but does not kick back...

Install bladder tank and pressure switch far from pump [ 12 Answers ]

My well pump is about 150 yards from my home where I want to install a bladder tank and pressure switch in my basement. I have been told that I can not do this because of the distance to my pump. I have a submersible well pump and the only place I have to put the bladder tank is in my basement. ...

View more questions Search