Ask Experts Questions for FREE Help !
Ask
    tdrury62's Avatar
    tdrury62 Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 18, 2014, 12:08 AM
    Furnace Operation Problem
    Furnace starts and stops numerous times before getting the house to the right temperature.
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
     
    #2

    Nov 18, 2014, 01:32 AM
    Hi tdrury62 and welcome, you need to give more information such as type and model to get the best answers. Good luck.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
     
    #3

    Nov 18, 2014, 06:39 PM
    What type of thermostat do you have? Is the "furnace" actually a boiler with hot water baseboard heat?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Problem: Build-up of gas inside dryer drum during operation. [ 1 Answers ]

Problem: Build-up of gas inside dryer drum during operation. Vents are clean and clear. No leaks from exterior gas piping connected to dryer. Ignition glow plug operates normally during cycle.

Furnace thermostat operation [ 3 Answers ]

Hi all! I'm sort of an electronic and computer nerd. I'm trying to figure out how the furnace thermostat actually works. I know the color codes, Rc & Rh are red (24vac), W is white (heating call), Y is yellow (cooling call), and G is green (fan). My question is, if I take the red (24vac) and...

Weathermaker furnace operation the furnace . [ 5 Answers ]

My weathermaker two speed furnace stars on high speed as it should, however it never goes to the lower level operation. Works very well on high but I would like to have it run more efficient. I wonder if there is a switch or program that controls this . I bought the furnace used and have no manual...

Troubleshooting furnace/AC blower operation [ 1 Answers ]

Hello my friends, I'll get right down to it. Owned home a year now, and I don't believe blower control circuit is set up right. Replaced plenum switch in winter, because the blower was not kicking into high when plenum was hot to disperse the heat. Now in summer with a/c... same problem. ...


View more questions Search