Ask Experts Questions for FREE Help !
Ask
    mgifford0128's Avatar
    mgifford0128 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 18, 2014, 09:06 AM
    Leaky Standard Shower after replacing stems. Cold water spins wide open.
    I have replaced the Stems in my Standard 3 stem shower and am still having problems. I am getting leaks off the H and C stems when I divert the water to the shower. I also have a problem with the cold water knob after I turn on the cold water it continues to open all the way on its own. Any Suggestions?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Nov 18, 2014, 03:05 PM
    First thing to try would be tightening the bonnet nuts on each stem.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #3

    Nov 18, 2014, 06:07 PM
    First thing to try would be tightening the bonnet nuts on each stem
    Yup! Sounds like a great place to start!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing shower stems [ 1 Answers ]

Replacing shower hot & cold water stems. Cold went on w/no problem. When hot installed, still have a small stream of water from tub spout. Question is how do the two small, white, plastic pieces, the black rubber piece (grommet?), & the white plastic gasket go into/onto the stem? No...

Replacing shower faucet stems eye [ 3 Answers ]

Found the correct Danco replacement stems - 4Z-24H/C. The package says "hot and cold stem for American Standard. I replaced the hot and cold stems, but the cold stem now turns the opposite way - backwards. Is there an adjustment on the stem to get it to turn t he other way?

Should faucet stems be open or closed when replacing [ 4 Answers ]

My husband is replacing the tub faucet stems; he is wanting to know if the new stem should be open or closed position when installing; Have installed them in the closed position and the water is very hard to turn on; (have to got buy another set of new handles first set broke when I tried...

Replacing Shower Valve Stems/Seats [ 1 Answers ]

Since the valve stems don't have a brand name anywhere on them I am concerned I may get the wrong size or thread type. Are plumbing parts consistent all across the board? I just can't seem to get this drip to stop completely. I can slow it down, but the washer ends up getting wrecked in about 3...

Replacing Shower Knobs & Stems [ 2 Answers ]

I am currently renting a condo that the landlord had bought replacement knobs for the shower before moving, but didn't have time to install them. He is out of state. I tried putting them on but they were the wrong ones and I happened to strip the brass parts that the knobs tighten up to. When I...

View more questions Search