Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Gas furnace won\'t reach temp. on thermostat
[ 1 Answers ]
I have gas furnace that will not reach temp. set on thermostat. I put new batteries in thermostat and change my air filter and I also had a furnace check in fall. The temp. is set to 90 degrees and it only reach 71. What else can I do?
Trane gas furnace only one gas burner ignites temporarily then shuts off
[ 1 Answers ]
Have a Trane XL80 furnace. We switch the furnace on but after the initial ignition it turns off. And then repeats about a minute later, and then again. Only one and sometimes three of the burners are temporarily igniting. We have removed and cleaned the heat sensor and replaced the igniter...
Trane gas furnace
[ 1 Answers ]
My gas heater is in the attic. When the attic get real cold (near or below freezing) the heater shut down. With a cold attic the igniter will come on, the gas will come on, then the flame, then 20 seconds later the gas shuts off. When the attic is not so cold every thing works fine. Temputure...
Do trane gas Furnace have belt and how to fix trane gas Furnace
[ 1 Answers ]
I have trane gas Furnace and its stopped working the pilot is not working its keep shutting off and also the switch on and off is working but the pilot and burner is not working what should I do ?:(
Gas Furnace will not reach temp
[ 4 Answers ]
Temp set to 64. 5 day programmable Honeywell from Home Depot. Had worked fine for over a year. Woke up at 50. Heat kicks on, got to 54 then shut off. I adjusted temp to 74. Still went to 54 then shuts off. Heater never blows for more than a few minutes. Decided to go to simple thermostat... View more questions Search
|