Ask Experts Questions for FREE Help !
Ask
    brismith's Avatar
    brismith Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 2, 2013, 08:08 PM
    Gas furnace won\'t reach temp. on thermostat
    I have gas furnace that will not reach temp. set on thermostat. I put new batteries in thermostat and change my air filter and I also had a furnace check in fall. The temp. is set to 90 degrees and it only reach 71. What else can I do?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jan 2, 2013, 08:19 PM
    Depending on where you live, 90 might be impossible. Why 90?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Won't reach the set temp won't turn on unless you blow on burners [ 1 Answers ]

We were sitting on watching TV tonight talking about how cold it is -24 when I said why is it not getting any warmer in here? We checked the temp and the inside temp was down to 65 but the set temp is set at 70. We went down to look at the furnace changed the air filter and replaced batteries on...

Funace won't reach desired temp. Then won't restart [ 0 Answers ]

I have a Bryant plus 90 furnace. Approx 8 years old. It will run for about 5 minutes then stop before reaching desired temp. Then it will try to start up again but shut down before ignition. Flipping power on and off will make it work again. I cleaned the flame sensor with no change. It appeard to...

My beckett furnace runs,but won't stay on long enough to reach desired temp [ 0 Answers ]

My beckett 55,000 btuh model afg runs but shuts down before desired heated temp.the computer panel was changed for 160.00.that did not fix the problem.it struggles to get warm in house

Gas furnace will not shut off at thermostat temp [ 1 Answers ]

I have an Armstrong Ultra II gas furnace and a Lux 1000 thermostat. I had this same problem with another thermostat and I installed the Lux 1000 and it worked fine for about six weeks and now it is starting to do it again. It is an intermittent problem. Any thoughts?

Gas Furnace will not reach temp [ 4 Answers ]

Temp set to 64. 5 day programmable Honeywell from Home Depot. Had worked fine for over a year. Woke up at 50. Heat kicks on, got to 54 then shut off. I adjusted temp to 74. Still went to 54 then shuts off. Heater never blows for more than a few minutes. Decided to go to simple thermostat...

View more questions Search