 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Changed distributor but not getting spark for my 91 honda accord
Car just stopped running one day while I was warming it up , sounded like it was running out of gas. Tried to start but , it would turn over but not start. I tried changing distributor but still no spark . Is it computer?
|
||||
|
||||
|
If the CEL consistently comes on for 2 seconds and then goes out, when the ignition switch is turned to ON (Position II), the ECM is likely good. Normally, installing a new Ignition Control Module (ICM) in the distributor (genuine Honda only) and coil solves the problem. If you replace the ICM, apply silicone heat transfer compound to its back; otherwise, it won't last long. Stay away from aftermarket distributor housings for Hondas--they are unreliable and often don't work, except for boat anchors.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I changed the distributor all internals main relay and still no spark I need help
Hello. I'm becoming TOO knowledgeable on my 1990 Honda Accord with 98K miles, it's been intermittent and not drivable for months now. Too expensive to replace the ECU or distributor (again) to troubleshoot. Last year replaced entire distributor, had no spark, this solved it. About 6 months later...
I have a 91 honda accord 4 cyl I just put in a new distributor a year ago Ran all right for the year then about 3 months ago it started over heating when I'd drive for more then 45 minutes About a month ago it started having battery problems The lights would shut off while I was driving or if...
02' Honda Acoord 4 cyl. Changed the distributor, crank sensor, main relay and still the car will not start. Can anyone help me.
I own a 91 Honda Accord DX. Just replaced the entire distributor, plugs and wires but not getting a spark at the plug. The CEL does not come on when truning the ingnition to Start or at crank. Could it be the ECM or other?
View more questions Search
|
