Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I replaced the seal on hot water faucet, but now I can't turn it off at faucet handle
[ 4 Answers ]
I replaced my hot water faucet gasket/seal and thought I reassembled it right but now I can not turn off the water at the faucet. Did I install wrong seal or reassembled the faucet wrongs. - Jack PS: I'm blond so I'm mechanically challenged... better type slowly!
Outside water faucet handle will not turn after putting valve back in.
[ 3 Answers ]
My outside faucet handle broke off. I finally got the rusted screw out and it started leaking. I pulled the valve stem out put it back in, put a new handle on and now the handle will not turn at all. I've tried to turn the screw part of the stem with a needle nose pliers without the handle on...
Hot cold water faucet handle is hard to turn
[ 0 Answers ]
I have a one handle bath tub water spout. The first part which is round turns the water on. Behind that is a handle that turns from cold to hot. That handle is turning hard. I have taken them off and there is a (looks like hex nut) on a pipe which goes into the wall. I do not know if that is...
Delta kitchen faucet low water pressure - single handle
[ 5 Answers ]
My single handle Delta kitchen faucet has lost pressure recently, especially the cold water, which is no more than a trickle. I've cleaned the aerators and replaced the seats and springs, but no improvement. Even with the aerator removed the pressure remains very low. I suspect a blockage... View more questions Search
|