Ask Experts Questions for FREE Help !
Ask
    hudsontc's Avatar
    hudsontc Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 11, 2014, 06:06 PM
    How to reset control panel on Kenmore elite dishwasher
    I have tried all the variations of Heated dry-Normal wash back and forth along with the sani-wash and heated dry that were listed on this site to reset the control panel on my Kenmore elite (665.19392) dishwasher. I still cannot get my dishwasher to run a test cycle. The bottom pump had come loose from the bottom of my dishwasher causing a major leak. I have attached that back to the bottom, but now can't get my "Complete" light to quit flashing. Any suggestions?
    talaniman's Avatar
    talaniman Posts: 54,325, Reputation: 10855
    Expert
    		  
    #2

    Aug 16, 2014, 04:57 AM
    Is your overfill protection float in the "down" position?

    How to Reset a Kenmore Dishwasher | eHow

    Check to be sure the overfill float is in the down position, as that will keep your dishwasher from running.
    http://www.partselect.com/Dishwasher...bly+repair.htm

    This assumes you correctly reinstalled the pump. Let us know if this fixes your problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do I reset my kenmore elite dishwasher? [ 1 Answers ]

How do I reset my kenmore elite dishwasher

How do I reset my kenmore elite 665 dishwasher? [ 26 Answers ]

I have a kenmore elite 665.16933 dishwasher. I think I need to reset it - I can only use the normal cycle and the other cycles (pots and pans, etc) won't kick on when pressed Anyone seen this before? Is there a way to reset the control panel?

How do you reset a kenmore dishwasher conrtol panel [ 1 Answers ]

Lock button is lite up and won't let be use dishwasher tried to hold the air dry button for 4 seconds like it says to unluck it but it won't unlock it. So now I can't use dishwaser at all. How do I reset the control panel

Kenmore elite dishwasher reset [ 0 Answers ]

I have a kenmore elite dishwasher 665.16033402 and the "clean" light stays on, I have used the posted info to reset the washer. I am able to start my washer but it only washes for about 20 minutes then the "clean" light goes on. I was wondering if anyone had the info on how to run a diagostic test...

Kenmore Elite Dishwasher 665.17462300 control panel is stuck. [ 2 Answers ]

Kenmore Elite Dishwasher 665.17462300 control panel is stuck. The "Normal Wash" and the "Cancel Drain" light are on continuously, with no blinking. I have disconnected power, checked power, removed control panel cover, reseated the ribbon cable connector, checked control board for burns, all...

View more questions Search