I have tried all the variations of Heated dry-Normal wash back and forth along with the sani-wash and heated dry that were listed on this site to reset the control panel on my Kenmore elite (665.19392) dishwasher. I still cannot get my dishwasher to run a test cycle. The bottom pump had come loose from the bottom of my dishwasher causing a major leak. I have attached that back to the bottom, but now can't get my "Complete" light to quit flashing. Any suggestions?

Is your overfill protection float in the "down" position?

How to Reset a Kenmore Dishwasher | eHow

Quote:

---

Check to be sure the overfill float is in the down position, as that will keep your dishwasher from running.

---

http://www.partselect.com/Dishwasher...bly+repair.htm

This assumes you correctly reinstalled the pump. Let us know if this fixes your problem.