Ask Experts Questions for FREE Help !
Ask
    blc1967's Avatar
    blc1967 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 11, 2014, 12:24 PM
    How to check if a pull cord spring is broken on a briggs and stratton 725
    I have a tory lawn mower the pull rope came out I removed all parts when I go to rewind the spring I turn the spool counter clock wise all I hear is click and there's no tension can spring be broken,
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Aug 11, 2014, 02:15 PM
    Most likely it has come loose fro its anchor point.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #3

    Aug 14, 2014, 08:31 PM
    Hi,
    Most of the current Briggs starters for thos model engines come with the pulley and spring as an assembly. The spring is already inserted into the pulley, requires careful removal of the tape that secures them together for shipment/handling and then is put in place.
    Provide engine model and type; I will link a parts breakdown and a part number.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Broken Bolens BL100 pull cord. [ 1 Answers ]

How is the pull cord on the Bolens BL100 reound after replacement?

I can't pull the starter cord on my 10hp Briggs and Stratton Engine [ 6 Answers ]

I recently purchased a two year old 10 hp Troy Built wood chipper. I've used it for about 4-5 hours and recently had to add a little oil. I added the correct type as per the manufacturers instructions. It started up just fine and after 15 minutes or so I shut it off to empty the bag. Once the...

Pull Cord won't pull on my Briggs and Stratton 650 Series push mower [ 5 Answers ]

Ok here goes... The pull cord is stuck. Its pulls out about 4 inches then the cord stops. Looking into the cord area ontop of mower, I notice a small white plastic piece getting caught in a notch built into the cord housing. Now... when I loosen the cord a little bit, I can slide a butter knife...

Pull cord on Briggs and Stratton [ 6 Answers ]

I have a Briggs & Stratton 5 hp 206cc magnatron. The cord was pulled out of place so I took it apart and it appeared to recoil just fine until I bolted it back onto the machine. Then... the cord did not go back in. Is there some way I can get the spring to rewind? :confused:

Briggs&Stratton Billy Goat Pull Start broken [ 3 Answers ]

Hey, my billy goat pull start is stuffed. When I pull it it goes floppy and won't wind back onto the wheel. Its happened before but when I've taken the top plate off it wound back on and I hadn't had trouble with it, until now. Is there anything I can do ?:confused:

View more questions Search