Luke warm water in shower with new Aquasource Garner mdl 873-3804

Check out some similar questions!

How do I remove the handle of a aquasource garner shower unit with no set screw [ 0 Answers ]

I just installed a new aquasource single handle shower faucet. I would like know how to remove the handle so I can adjust the hot water.

Only luke warm water from mixer shower [ 0 Answers ]

I had a new shower installed over my bath, it been working fine however now there only seems to be warmish water coming out when the bath tap & any other taps are producing hot water. The showers assisted by a pump & I've always had to lower the shower head when turning it on to make sure the...

Help with my AquaSource shower kit 873-4604! [ 2 Answers ]

I have an AquaSource shower kit #873-4604. The on-off handle comes off in my hand and I can't figure out what part is missing. Is there a screw that goes in on the outside where there is a hole, and if so what size? Also when holding the handle in my hand, I can see a long screw inside the main...

I have only luke warm water in one shower. [ 2 Answers ]

It is a Moen single handle faucet. I have replaced the cartridge but I still only get hot water for a few seconds and then it is still only luke warm.

Luke warm water from shower [ 3 Answers ]

Over the last few months I have noticed that my shower is not producing hot water the way that it used to. The sink tap gives out hot water, just not the shower anymore. I have noticed that when I flush the toilet there is an added burst of pressure from the shower. Do you have any idea what this...

View more questions Search

Check out some similar questions!

Add your answer here.