Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Proper wiring for 240V elec wall heater with two 120V supply lines
[ 2 Answers ]
I have an older 240V 1000W electric wall heater (no fan, built-in thermostat) which has 2 gray wires for attaching incoming supply. One gray line goes through the thermostat then on to one end of the heating coil itself. The other gray line goes directly to the other end of the heating coil. ...
What is the proper distance of closet drain ring above finished floor?
[ 3 Answers ]
What is the proper distance of closet drain ring above finished floor?
Maximum distance of a sanitary appliance from a water heater
[ 1 Answers ]
I am working on the plumbing of a villa. It has three storeys, only one water heater is to be placed in the basement (must). There are 15 bath rooms. The height from the basement to top floor is 50 ft and the horizontal distance is 80 ft. This makes a total distance of 155 ft excluding friction...
1/2 copper, proper distance between hangers?
[ 5 Answers ]
How far apart do 1/2 copper pipes need to be supported on straight runs?
Using the proper gage wire fro long distance outside run
[ 3 Answers ]
Hi, 1) I am looking to run a 460' wire to an 5-wheel trailer - which I understand needs a 30 amp circuit. For the AC particularly, and need to figure out what is the proper gage wire to use.:confused: 2) Also, I am told that I can not run romex wires in a conduit outside, is that true?:mad: ... View more questions Search
|