Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
We have lost water to our hose, in the pump house the submersible pump motor trips
[ 3 Answers ]
We lost water, so we went to the pump house the submersible pump motor tripped, we clicked the reset button and it builds pressure to about 38 PSI then trips again, so we replaced the motor, no change does same problem, so we replaced the 30/50 pressure switch, same problem exists.
I left the water hose on until we ran out of water. Do I just need to prime the pump
[ 1 Answers ]
I left the water hose on until we ran out of water. Do I just need to prime the well pump to get it going?
20 gallon vs 30/38 gallon electric hot water heater?
[ 12 Answers ]
I am faced with the same hot water heater question as others. I am building a small utility building on property on Texas Gulf Coast. Within this building I want to put a small shower stall with a hot water heater to supply this shower and occasionally use a washer. It will be for...
Well pump not producing enough water to fill a garden hose?
[ 6 Answers ]
I have a well but haven't used it since last year. Went to use it and the sprinkler starts great but only last a few minutes then no pressure or hardly any water. Checked pressure tank and added 8 lbs of air pressure when tank was empty. This did not make a difference. The pump is running as I...
Length of Sump Pump exhause hose/pipe
[ 2 Answers ]
Sump Pump hose length - how long of a hose/pipe can I safely connect to my sump pump without risk of damage or wearing it out? My current setup is that the pump, pumps up a PVC pipe (9') then out to the exterior which is 15', from the exterior I have about 30' of PVS which is sloped, then about... View more questions Search
|