 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
1998 Honda Civic EX 1.6 SOHC
Car is "Flooding" after warmed up and sits for at least 30 minutes. Tried pulling plugs as soon as it fires (usually second or two) and the same plugs are not always wet. Sometimes 1 & 3, next time 2,3,4. If leaky injector I would think the same ones would always be wet.
Replaced: ECU temperature sensor, Rotor, Cap, Coil, Plug wires - All aftermarket, not OEM. This issue surfaced after radiator blew antifreeze on motor. Replaced radiator, thermostat & bleed air. Has used no coolant in 300 miles. Temperature gauge is rock solid at about 40%. Ideas other than bringing to a car crusher? Thanks, Dave |
||||
|
||||
|
The wet plugs indicates that the ignition system is compromised. The most likely culprit is the Ignition Control Module (ICM), if it has not been replaced in 125,000 miles or 10 years. If you decide to replace it, be sure to apply silicone heat transfer compound to the back of the new ICM, otherwise it won't last long.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hello, I am looking for the right model/number for the engine computer of my 1992 Honda Civic. I tried using the VIN with a Honda dealer, but they were only able to give me a partial nomenclature 37820. Another dealer told me the last three digits are A50. Form a little more research what I have...
My1995 Honda Civic DX 1.5L SOHC Will Not Start. I Initially Started My Car To Move It Out Of A Tow-zone In A Parking Lot. I Made It All Of 50 Feet Before My Power Drastically Reduced And My Engine Killed. The Battery Was Quite Old, So I Replaced It With A New One. I Wasn't Successful Jumping My Car...
My car starts very normal when very cold and when the engine is already on tempeature. But between there it starts difficult . You can smell the overloaded gasoline in the car!! I Found 2 errors which are Code 6 and Code 14 ( water temperature sensor and IAC valve ). I've already changed the IAC...
I am having trouble with my honda. I have replaced the engine in the car, and now I have a code 15 blinking at me from the dashboard. In trying to diagnose my problem, or problems I have replaced the distributor, and the electrical component in the ignition switch. The code 15 is the ignition...
I just installed a new distributor I thought I lined up everything right... it starts runs but when I press on the gas it doesn't have any power any ideas?
View more questions Search
|
