 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Can I connect low pressure basin tap to shower pump
Hi,
Changed monobloc mixer tap on basin to Led waterfall tap, only problem is not enough pressure to operate tap. I do have a power shower pump near by can I connect tap to this? Cold water tank is as high as it will go. |
||||
|
||||
|
I don't see any problem why it should not work. If you get too much water flow from the sink top after the pump is connected, turn down sink shut off valve under the sink until you get desired water flow. That will restrict a flow a bit and at the same time it will regulate water flow. Hope that helps. Let me know how it went. Milo
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Can I connect the basin supplies to the shower pump?
I have installed a new mixer tap in my kitchen (Monaco Pull Out Tap Chrome Finish) but since I have installed it I have lost pressure when in hot and takes longer to heat up, sure there are no blockages but have a feeling it is the tap or hose that is not compatible for "low pressure"? The cold...
Hi. Ihave just had a(Grant) combi boiler fitted, my shower used to have a pump on it but has now been removed when the new system was fitted. If the shower is running and I turn the cold water on ,at the basin there is a small drop in pressure as you might expect but when I then turn this back...
Had to shut the water off to whole home for a fixit. Did the repair and turned water back on. Bled all lines and all taps/fixtures are fine except sink in master bath which just trickles. Was running fine before shut off. Any ideas? Thanks in advance.
Hi can anyone help I have just installed a new mixer tap on my kitchen sink with a removable shower head the cold water is fine but the pressure on the hot is terrible is there any way to make it better?
View more questions Search
|
