Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How tight should I make the flex line and fitting when connecting a gas dryer.
[ 1 Answers ]
I replaced a non-working gas dryer with a new one. A flex line was already connected to the supply line so I used the female end that was connected to the old dryer and tried to connect it to the new dryer. Since the male part of dryer was smaller than the female part of the flex line, I had to...
How to increase pressure in supply line after addition of tee in line(05
[ 2 Answers ]
I added an outdoor frostfree water valve to the cold water supply line by teeing it in. The supply lines is .5 inch copper pipe as is the added line and fittings. The water source is a well. The water pressure seems to have dropped a lot even when using only one faucet at a time. The added line is...
The gas line broke on a Ryobi 725r and I need to know the diameter of the line.
[ 1 Answers ]
The gas line broke on a Ryobi 725r and I need to know the diameter of the line.
Connection to gas range gas line too large for gas line intake valve
[ 2 Answers ]
Connection to gas range gas line too large for gas line intake valve. How can I step the range back line down a step. Is there some kind of converter I can buy?
Sanitary Tee Vs and Tee w/ longer sweep
[ 2 Answers ]
It seems obvious, but I wonder what the logic is behind the use of a short radius elbow or sanitary tee vs one of the long sweep elbows or tees in a sewer rough in. Is it only for lines w/ solids or large volumes in laterals or drains? Or are the longer sweeps more for vertical stack... View more questions Search
|