Ask Experts Questions for FREE Help !
Ask
    joannepatti's Avatar
    joannepatti Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 19, 2014, 04:41 PM
    How to bleed a water pump davey
    I've got a davey hp45-05 water pump it was making a loud noise so I turned it of and on again and the loud noise stopped . Now one toilet flushing is filling up slowly and the other is not filling at all . I noticed that a pipe that goes from the water tank to the pump was dripping so I pulled it off and replaced the tread tape , so that's not dripping any more . But the toilet flushing are still the same .
    What could be my problem do I need to bleed the pump and if yes how do I .
    Thanks
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    May 20, 2014, 07:59 AM
    If the PS I remain the same then the pump noise should not affect your toilet. What should have happened is that one of the impeller blades when bad and debris is I'll your ballcocks. Are there any faucet that has stopped working? Let me know, Tom
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #3

    May 20, 2014, 04:40 PM
    Check your gauge. What is it reading?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to bleed a shallow well pump [ 4 Answers ]

I just installed a new shallow well pump and primed it.it's suppose to kick on at 20psi and of at 40psi. It goes up to 20 and the gage just bounces around there. I was told to get pressure I may need to bleed the air out. Any suggestions on how to bleed the pump and lines?

Well water pump-how to Prime or bleed it? [ 7 Answers ]

:confused: :confused: When running the water.. every few minutes.. it will stop for a few seconds.. and you will hear it start up again. This has just started to happen in the last few months.. and I was told it might need to be primed or blead. I have no idea how to do this! Will I need to contact...

How do you bleed the pump on oil furnace [ 1 Answers ]

I ran out of heating oil. I just put oil in and the burner won't kick on. How do you bleed it

Davey booster pumps [ 1 Answers ]

I have a davey pressure/distribution pump that is about four years old and is driving me crazy. It will often stop pumping and if you turn off the power and turn it back on it works fine for perhaps a day or two and then the same thing happen again. I checked the little tank on top of the pump...

Bleed brakes--max torque to close bleed valve screw? [ 1 Answers ]

Working on a '99 Miata. Changed the right rear caliper, but cannot find information on the maximum torque to close the bleed valve screw. My repair manual does not have this information nor the Kragen store nor the website of the manufacturer--Cardone. Any help will be appreciated. Thanks.

View more questions Search