 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How to Troubleshoot a Square-D Pump Pressure Switch | eHow
Your Square-D pump pressure switch is a gray box that is normally mounted to (or near) the water supply pipe, and it has an electrical cable or conduit attached to it.
|
||||
|
||||
|
Remove the grey cover. There are two nuts underneath. Turn the larger of the two clockwise to raise both the cut in and cut off pressures, and ccw to lower those pressures. Don't be timid. Think in terms of one full turn at a time. It's a matter or trial and error to get it where you want it. Most people turn off the breaker when adjusting.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
The water is barely running out of my faucets. It worked fine yesterday. Did my tank just go?
Can anyone tell/explin how to property replace the points on a D model PumpTro control switch ( very old switch about 1980 ) Bill
How do I prime a well-x-trol pump? I shut it off to replace a faucet and lost pressure
I am changing a pressure tank for a catchment water system (here in Hawaii some rural houses do not have county water so we catch water from the roof and it is stored in a tank , in this case, below the house so it needs to be pumped up to the faucets. My question is, after I disassemble the pump...
I recently replaced a well pump. After the pump was replaced, within a day, we started to get low water pressure in the house. It starts strong for about 30 sec, and then it gets very low - not to a tricle- but not strong either. I've been reading other threads, and thought about increasing...
View more questions Search
|
