Ask Experts Questions for FREE Help !
Ask
    slivino's Avatar
    slivino Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 11, 2007, 09:10 AM
    Instant Hot Water Heater
    Q: 1
    I am installing a 2.5 gal Ariston instant hot water heater. The diagram shows a 3/4 NPT male temperature and pressure relief valve that needs a set up to discharge in the drain.

    I am in a rental and not able to access the plumbing in the wall.

    A. Is there a way to hook into the drain from the sink?

    If not

    B. Is there a safe alternative for the realease valve ( currently it is positioned towards the wall with no H2O access to any electrical wiring or ungrounded appliance.

    Thank you,

    Sharon
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Apr 11, 2007, 09:36 AM
    Sharon, this isn't much of an answer, more of a question before we begin the installation. As a landlord I would not allow a tenant to install any fixtures. Have you talked to your landlord about this idea and why isn't he taking care of it. The instant heaters require both 110 vac to run the electronics as well as 220 vac or gas for the fuel. It doesn't sound like you have power in the immediate area. What type of heater is currently installed? Tell me a bit more on question B, is this regarding the new heater or an existing heater?
    Back to you.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Brand new water heater: Starts hot, then water gets cold after few seconds [ 9 Answers ]

We just moved into a brand new condo which has its own water heater. We went to take a shower this morning and the first few seconds of the shower were very hot, then it went cold after 10 seconds. We tried again after half an hour, same thing. There was enough hot water for my husband to shave but...

Instant hot water with PEX system [ 1 Answers ]

Is there a way for me to get instant hot water to a faucet using a PEX manifold system? Or can I run the cold through the manifold and loop the hot?

No hot water - hot water heater and cold working [ 1 Answers ]

HELP! Its freezing out and we have NO hot water! Cold is working fine everywhere - but nothing comes out of the hot side anywhere. The hot water heater appears to be working? Did the hot water pipes freeze? Why the hot side and not the cold? Please help.

Hot Water Heater not keeping water hot [ 1 Answers ]

Hi I am having trouble with my hot water heater. I believe it's a gas water heater. I have a problem with my water not staying hot. I have no problem getting hot water in the morning if I've run the dishwasher or the washer the night before. However If I haven't used much water recently, the...

Instant Hot Water dispenser vs. Side sprayer [ 2 Answers ]

I want to add an Instant hot water dispenser to my stainless steel sink. It already has a side-sprayer through the hole I want to use to install the dispenser. 1) Can I use that hole & 2) how do I defeat the side-sprayer hose and eliminate it under the sink?


View more questions Search