 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
MODEL # 7900-7741/A heating and A/C unit
I had to replace the part that you sand paper down. Since then I have had problems with stat, replaced it now, and my next problem is that when I turn on the a/c, heat comes out I have a a/c and heating expert but mainly works on commercial units not a trailer unit. I need help bad or instructions of some sort. The only thing he can think is the heat pump and I am praying it is not that, I have already put enough money in this red t products unit. Any one that may have a answer please help me. Thank you so much.
|
||||
Check out some similar questions!
If I turn the unit on for heat or air the blower turns on and that's it. I was getting a flashing LED code 33, then I tapped the limit switch. Now I'm getting a code 12. Stll only the blower turns on. Any ideas? Thanks
When the outside A/C unit cuts off the fan inside stays on. I tried changing the thermostat already. Do you think it is the fan relay? Is that on the circuit board?
Have a five year old unit that now has a dead Induced Fan Motor. Just told by contractor that this unit just went off waranty in June, and I have to pay $134.76 for a motor to make my 5 year old heater work. Is this a common problem with this Brand/Model or do these fans normally have a life span...
I recently moved into a mobile home that has an Intertherm Inc. Model 9007590 Heating/Cooling unit. I am trying to use the AC and when I turn both the thermostat and the unit to 'cool' the fan will not shut off on the unit. I have turned the thermostat up to 80 and it still runs. How do I get it...
I have a 1987 Coleman 7900 series heating unit that seams to work until it kicks off before reaching the temp set on the thermostat, leaving the pilot extinguished as well. The blower continues to run for a few minutes and then shuts off. Now because the pilot is no longer lit the unit cannot...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
