Ask Experts Questions for FREE Help !
Ask
    Wmaxpeterson's Avatar
    Wmaxpeterson Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 28, 2014, 05:04 PM
    State select gas water heater model pr675xrvit has no power to gas valve.
    The water heater quit working. I found that water supply was leaking so I tightened the connection and that fixed the leak. Now there is no power to the gas valve. I checked power at toggle switch and all is good. When looking at igniter I encountered water at the flame sensor and the insulation had deteriorated on the wire. The insulation around the water tank is saturated as well. Is there some kind of reset other than the hood reset?
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Jan 28, 2014, 05:13 PM
    The number you posted suggests a power vented water heater. These power vented water heaters are notoriously difficult to troubleshoot online (could take hours of back and forth typing and still not resolve the issue).

    I suggest that you contact State industries directly...click on this link:

    State Industries | Customer Service | Cross Reference Guide

    Finally, it is probably a good idea to shut the "hood reset", wait five minutes and then turn power back on...see if that resolves the issue, OK?

    Good luck!

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does a state select water heater gas valve have a pilot flame adjustment screw? [ 1 Answers ]

I have a state select water heater and I changed out my thermalcouple and replaced the gas valve. The pilot would not light. so now the pilot light does stay on but goes off once in awhile. There is no draft. It appears to go off at times after the main burner lites . It gets frustratiing. Any...

State Select Gas Water Heater? [ 1 Answers ]

I have been requested to install a drip leg/sediment trap on the gas supply to the water htr. The heater was installed in 2008.is this a code requirement now if it is does it need to be installed on a4yr.old installation

State Select gas water heater Model PR 650 NRRTL, 50 gallons uni [ 2 Answers ]

I have a State Select gas water heater Model PR 650 NRRTL, 50 gallons unit. Does anyone know which configuration the valves haft to be in, in order to switch from heat to air conditioning? Any advice or help is greatly appreciated.

State select 75 gal water heater pr675xrvit about 4 yrs old. Fail to ignite. [ 3 Answers ]

Gas water heater. 75 gallons. State select model pr6 75 xrvit. Installed in 2005. Has been working well. Last few weeks, it stopped to come on. I was abled to cycle the ON-OFF toggle switch and restart. Usually take a few try. The LED status light shows 101001. According to the manual:...

View more questions Search