Ask Experts Questions for FREE Help !
Ask
    jpvt96's Avatar
    jpvt96 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 12, 2014, 05:08 PM
    Whole home generator gfci tripped on control panel
    I have a bryant (apparently made by generac) 15,000W, had in place since I built in 2007. On the control panel on the unit, beside the buss fuses is a small GFCI plunger-type breaker. It has popped up. I cannot find a reset anywhere to get the unit back online. I'm waiting on my dealer but probably another week out while he fixes people who had no heat during this cold blast. Up until this week, it was working fine, did the self check each week, etc. The battery is charged and both the 7.5 and 15 amp fuses are good. Any ideas?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jan 12, 2014, 05:35 PM
    What happens when you push in the "plunger" on the GFCI
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What do I need to connect a DSC 1832 control panel to a Control 4 home automation sys [ 2 Answers ]

What do I need to connect a DSC 1832 control panel to a Control 4 home automation system?

Generator wiring: new generator gfci breaker tripping [ 2 Answers ]

Generator wiring: I have a new honda generator. I ran 3 wires from the garage to the transfer switch in the house. When I start up and throw in the breaker on the generator, its GFCI trips immediately. It is a long run (125ft) run to the house and I used heavy wires. But I only ran 3 (blk,...

Is it OK to place GFCI on the main and not the sub panel for a spa [ 2 Answers ]

Over the weekend I helped a friend install his spa. The spa had 5 connections and 1 ground. 2 30A, 2 20A, and a neutral. We installed a 50A GFCI to the main electrical panel on the house. Then we ran that to a sub 100A panel with a reg. 20a and 30a breaker in it. Then ran it to the spa. The spa...

When adding a GFCI disconnect for hottub, should I replace GFCI in service panel? [ 4 Answers ]

I have a hottub now but without a disconnect. Its simply a 6/3-50 amp wire that runs from the hottub to a 50amp GFCI inside the house main service panel. I want to install a disconnect 5-10 feet from the hottub. I bought a disconnect box that already has a GFCI inside of it. Should I have bought...

Gfci spa panel tripping [ 4 Answers ]

I just installed a spa with 4 wires. The house is old and while the neutral & ground bus bars are separate in the spa panel, they are all on the same bar in the main panel. Do I need to install a ground rod by the spa panel to keep the gfci from tripping? (instead of running the ground back to the...

View more questions Search