Beckett burner fires and shuts off after a few seconds

adam51 Posts: 1, Reputation: 1

New Member

Jan 6, 2014, 07:00 PM

Beckett burner fires and shuts off after a few seconds

I bled the system, Oil burner starts and runs than shuts off. Push reset and cycle repeats. Flame looks good as well. What could be wrong?

Grady White Posts: 1,417, Reputation: 59

Ultra Member

Jan 6, 2014, 07:02 PM

What make & model is the control on the burner?

Add your answer here.

Check out some similar questions!

I have a Frigidaire gas furnace which fires up for a couple of seconds then gas shuts [ 1 Answers ]

My Frigidaire gas furnace has 3 burners that ignite for a couple of seconds then shuts off. The electric ignition and fan works fine, it's just the burners that turns off after a few seconds. If I try turning the furnace on and off a few times it sometimes fires up and stays on. I have tried...

I have a Frigidaire gas furnace which fires up for a couple of seconds then gas shuts [ 0 Answers ]

My Frigidaire gas furnace has 3 burners that ignite for a couple of seconds then shuts off. The electric ignition and fan works fine, it just the burners that turns off. If I try turning the furnace on and off a few times it sometimes fires up and stays on.

Beckett burner fires then will not fire again [ 0 Answers ]

My burner fires, will run for 10, 15, minutes, sometimes it will do one cycle, maybe even two or three. Then will not fire again the reset pops up and it has to be reset before it runs again. Got any ideas

I cleaned the ignitor and the first burner lights, for a few seconds then shuts off [ 0 Answers ]

The fan is running, I changed the position of the ignitor and got the flame to stay lit and the furnace is running; but it will run until therm temp setting is met then will turn off like normal. But when it fires up again, the flame will not stay lit. I cleaned the ignitor and temporarily removed...

Oil Burner Beckett AFG - shuts down after 25 secs [ 3 Answers ]

Oil heat not running this morning. Cleaned nozzle. While burner was out of furnace I installed the new motor which I had ordered a month ago - the original had noisy bearings. Re-assembled everything and ran furnace. Lights up immediately, runs for 25 secs and then flame goes out. Motor runs until...