Ask Experts Questions for FREE Help !
Ask
    Don George's Avatar
    Don George Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 2, 2013, 08:27 PM
    Bryant furnace starts fires up,but goes out
    As soon as glow stick goes out so does the flame installed new flame sensor,still same problem
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Dec 2, 2013, 08:37 PM
    Check all of the grounds. Make sure they are clean & tight. Also make sure the flame sensor is completely wrapped by the flame & the rod is not touching any metal.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant mod.383ka furnace shuts down when igniter starts [ 3 Answers ]

Bryant 383ka plus 80 shuts down when igniter starts

My Bryant furnace is very inconsistent when it fires up [ 1 Answers ]

My furnace appears to go through it's sequence normally, but when the burners ignite they shudder and choke for 1 or 2 seconds and than everything appears to be okay after this. It almost seems like they are being choked out for a quick second and then brought back to life. Any idea what this could...

XB80 Gas Furnace , furnace fires up fan turns on but no airflow in ducts [ 2 Answers ]

Furnace fires up just fine, and fan spins but there is absolutely no airflow in duct work. Any ideas? Last spring thermostat went out and I replaced it, worked great. A month later circuit board burned out, tech found that problem and replaced it (major pocketbook ouch) and everything worked...

Bryant gas furnace starts OK - but blower stops after a few minutes [ 1 Answers ]

My Bryant gas furnace (394GAD I think) starts up in heating cycle OK - but after a few minutes the blower shuts off. The burners stay on. Then 30 seconds or so later, the blower restarts. After a few minutes, it shuts off again - burners still on - then starts again after 30 seconds. Repeats this...

Bryant furnace starts then stops [ 3 Answers ]

My Bryant forced hot air furnace gets the signal to ignite, the pilot light and then the furnace lights but it goes out in a few seconds. This will happen over and over and then occasionally it might stay lit and warm the house. Any ideas of what this could be and how to fix it. Much...

View more questions Search