Ask Experts Questions for FREE Help !
Ask
    Tgfu101's Avatar
    Tgfu101 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 30, 2013, 09:17 AM
    Code 12 red flashes
    York high efficiently diamond 80

    Had a twining error off and restart then OK for a few cycles. Then when tried to reset the inducer motor would run for a few seconds then stop and there were 12 flashes which is not on the code list.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Nov 30, 2013, 07:58 PM
    Is there another furnace twinned with the one giving you the code?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Error code 2 red flashes for rheem furnace [ 1 Answers ]

Igniter does not spark, induction motor runs, no burner flame. 2 red flashes on board - Rheem RKKA

Code light flashes [ 1 Answers ]

I have a Red T furnace I'm not sure the model, but the code light flashes four times. A sticker on it tells me that a regulator switch is the problem. I located the switches with the help of the wiring diagram. My question is, can I replace these switches myself and where can I get them if so?

Status code of five flashes [ 0 Answers ]

I have checked the ground from disconnect box to the unit and also checked ground from control board to ensure they were grounded properly. Each time when I restore power, I still get five flashes. Is the control board bad?

Furnace not running,code flashes 3short flashes by 1 long flash on a bryant 90 t [ 2 Answers ]

Code flahes 3 short flashes by 1 long flash

My furnace fault code light flashes three times the pause and flashes three times aga [ 3 Answers ]

My furnace fault code light flashes three times the pause and flashes three times again and repeats. What is wrong?

View more questions Search