 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Pressure Switch Open Inducer On
My furnace is only 4 yrs old, believe it is high efficiency. This morning it was not working properly. It would start on and right before the flame fired it would shut down. The code was pressure switch open inducer on. I saw that "mygirlsdad77' mentioned there needs to be water in the drain trap so it creates a vacuum. My little clear line going from the vent to the drain had condensation in it so I shook it loose and there is now a little bit of water in the bottom of the line and the furnace is staying on... Is there anything I can do to prevent it from turning off again?
|
||||
Check out some similar questions!
I have a concord 80 plus furnace. I tried turning it on and it runs for a few seconds and shuts off. Sometimes it will ignite and sometimes it won't. I replaced the flame sensor and the pressure switch, I have sucked/blown on the tube and cleaned what the tube connects to with a small piece of wire...
LED light indicates this error
I have an intertherm propane furnace, new in 2006 we just turned propane back on for the year, and it won't light. The red light is blinking 2 times & indicates "pressure switch open with inducer on" however I have no idea what that means or how to troubleshoot to fix. It hums like always before it...
Hello all. I have a Gibson forced air furnace I've been having trouble with the last couple of days. At first, the unit would start up... Inducer comes on, about 20 sec later the ignition coil starts to glow, the gas would turn on and ignite and it would run for a short period. There is an amber...
Brand new ducane gas furnace has this error any suggestions?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
