 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Tempstar furnace will start and ignite, runs to reach temp, then 2 blinks
The furnace will run as normal to reach the set temp, once that occurs it shuts down, with small turbine still running, and then if temp drops below or is set higher the unit clicks and led changes from heartbeat flash to 2 flashes.
|
||||
Check out some similar questions!
My Tempstar furnace will ignite and then go out when calling for heat. This will repeat itself several times before remaining lit. Any suggestions for repair? I have taken the pilot assembly off and cleaning it. Cleaned the sensor wire connection and all mating surfaces.I do know it is a smart...
Furnace goes on and then you hear the click but will not lite. There is no glow in fire box. Small red lite blinks three time then wait a couple seconds and blink again and does it again and again
My beckett 55,000 btuh model afg runs but shuts down before desired heated temp.the computer panel was changed for 160.00.that did not fix the problem.it struggles to get warm in house
I have a similar problem re: a gas furnace that stops before reaching the desired temperature on the thermostat. I just replaced my old analog thermostat with a new digital programmable one but the problem persists. I replaced the furnace filter and cleaned the dust from the furnace but this did...
Temp set to 64. 5 day programmable Honeywell from Home Depot. Had worked fine for over a year. Woke up at 50. Heat kicks on, got to 54 then shut off. I adjusted temp to 74. Still went to 54 then shuts off. Heater never blows for more than a few minutes. Decided to go to simple thermostat...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
