Ask Experts Questions for FREE Help !
Ask
    Mike Savage's Avatar
    Mike Savage Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 16, 2013, 08:17 PM
    Fixing maytag dryer moisture sensor
    We have an electric Maytag dryer that will run about 15 seconds and then automatically shuts off. Ant suggestions?
    Mike
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
     
    #2

    Oct 17, 2013, 09:33 PM
    These driers will do that when the lint builds up like concrete on the inside of the air ducts. The heating elements have zero to do with anything. It's so full of dirt the next thing it will do is to catch on fire and burn down your house. Also, the sensors get blocked from sensing when the dryer is dirty. You have to totally tear it down piece by piece. Halfway cleaning it will not work because all it takes is one clogged up air passage or dirty sensor. You need to totally tear it down and scrape out and wash all of the parts except the motor, which you vacuum out. You can go to YouTube to see videos on how to take it apart, but do a very good job or it will fail again quickly. I would get a new belt and change it while you have it apart and get some white lithium grease and grease any bearings you find. You need to clean out a drier every two years, at least, according to the manual. You just unplug the wires from the sensors and remove ductwork that they are attached on and clean the entire thing with soap and water. Make sure you go all through the dryer and get all parts like the blower fan and housing (it has to be scrubbed and washed out), vacuum out motor well and clean exhaust. Mark all wires you unplug so you know where they go. If you leave any dirt in the ducts it will blow another fuse quickly or will not maintain the temperature correctly. This is an easier job than you would think. Make sure to clean around all of the sensors, if it has them. You can check them with a meter and the chart in one of the manuals, too. See: Dryer vent cleaning prevents fires - YouTube and: Cleaning out a dryer with top lint cleanout - YouTube
    Cleaning out a dryer: By a woman 2 of 2 - YouTube
    Manuals: https://dl.dropboxusercontent.com/u/...g%20Dryers.zip

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Maytag Dryer 3000 Sensor Cleaning [ 6 Answers ]

I have the Maytag 300 series. These are excellent machines; however, we had a problem with the dryer shutting off too early. The repairman told us that the sensor(s) needed to be cleaned occasionly with rubbing alcohol. Problem is, I was not present at the time and do not know the location of the...

417.8204101 manual to replace moisture sensor [ 1 Answers ]

Kenmore Dryer Manual?

Dryer won't heat up moisture sensor wires not on [ 1 Answers ]

Hi This is my first time asking a question. My handyman husband fixed my maytag electric dryer today. It was making a lot of noise, rollers on drum needed replaced. Sounds wonderful now, no noise. The problem is he had two blue wires left after he thought he put it back together, his...

Fixing dryer [ 6 Answers ]

I am in the process of fixing my own dryer. The symptoms: initially, a squeaking that would last for a couple minutes then go away after the dryer warmed up. Then, over time, it would squeak loudly the entire time the dryer ran. This is caused by the "rear bearing" going bad, or getting worn...


View more questions Search