 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Burner does not relight.
I'm working with a Heil gas furnace model # NOG5050BEA2. The unit works fine for a few days and then the burner goes out and the blower motor stops but the evacuation motor keeps going and the thermostat is calling for heat. The burner will not relight unless the thermostat is lowered to drop the call for heat. After a short while the unit will work fine again for an intermittent time. Sometimes days and then sometimes just hours. The burner has been adjusted and the thermostat has been replaced. Also replaced the rollout limit switch. Have improved the air to unit. Any suggestions would be appreciated...
|
||||
Check out some similar questions!
I'm looking for a cap to cover the pilot relight/inspection hole on my propane furnace. The furnace manufacturer (Temco) is no longer in business. The furnace works, has been serviced. The only missing piece is the cover cap for the pilot relight. Thank you.
My Tempstar DC90 furnace will not relight after shutting off. Inside temp raises furnace shuts off. But when temp drops the furnace will not relight but the blower/fan will start up. I have shut off thermostat and furnace and restarted.It will light and run until temp set point. Board was replaced...
It says aire-flo on the front of it and I don't know how to light it
] have a gas wall heater. The pilot light blew out while I was vacuming the heater. I've follow the instructions for turing it off and back to pilot and pushed in the button. I cannot figure out how to light the pilot. The instructions are very difficult to see. Thanks
I have a 1987 Byrant Plus 90 furnace. The other day the wheel on the inducer motor lost a couple of blades. I replaced it installed a new wheel and the motor. Plugged everyhting in but the pilot light would not stay lit. I removed the cover cleaned the pilot light area and the gas orfices. The...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
