Ask Experts Questions for FREE Help !
Ask
    tactical's Avatar
    tactical Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 12, 2013, 07:36 PM
    What is the voltage drop running 2/0 quadplex 350'?
    I'm powering a sub panel that is 350' from the main. Is 2/0 quadplex wire OK or is the voltage drop too much?
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #2

    Oct 13, 2013, 04:11 AM
    Sorry, but what you are asking is like asking "How big is a ball? Is 16" big enough?"

    What size panel?
    What size feeder breaker?
    AL or CU wire?
    What is the calculated load?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Voltage drop [ 3 Answers ]

Up until 2 weeks ago my spot lights were working fine, switched on 1 day and they popped checked voltage at light point and it was 70v. Disconnected switch line at switch checked voltage on feed and it was OK at 235v .Whilst still disconnected from switch I send a live feed up switch line and got...

I have a1996 F-350 diesel the voltage meter on the dash started swinging [ 1 Answers ]

I have a 1996 F-350 the voltage started swinging.I notice it on the dash gauge. Had the altenator tested it tested o.k. I checked all the wiring connections they were o.k. sometimes the voltage swings to where the battery light starts blinking on and off. Then there times the voltage stays steady....

Voltage drop [ 4 Answers ]

Can someone please post the formula for voltage drop? Many thanks.

Voltage Drop [ 3 Answers ]

I am trying to illuminate a tunnel about 3000' long temporarily with 9- 400 Watt Metal Halide fixtures spaced about 320' apart. I have a 120/240 generator single phase that I will use to back feed a 240/480 volt transformer to deliver 480 volts, single phase to the tunnel lights. At 480 volts I...

Voltage drop [ 2 Answers ]

How far can you run an electrical cord, that is plugged into a 20 amp circuit, and still run a circular saw? If the saw starts slowly, will that harm the saw?

View more questions Search