Ask Experts Questions for FREE Help !
Ask
    Reparatie's Avatar
    Reparatie Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 10, 2013, 06:50 AM
    Generac 7550exl how to remove carburator completely
    Problem: gas coming out of air filter. Thinking needle stuck.
    Removed air filter, removed nuts carburator. How to remove extended spring throttle wire attached to carb without bending it. Was able to remove bowl and sprayed with cleaner and air, but little 3 mm rubber( I think to close something off came out. Where is this coming from?
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Oct 10, 2013, 06:58 AM
    Try here:
    Generac Generator Carb removal and disassembly - YouTube
    Reparatie's Avatar
    Reparatie Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 10, 2013, 07:17 AM
    Thank you Stratmando, but I have watched this utube, but this is a different model. On carb site bended end of spring is thicker and will not go through this size of hole. Spring will go through engine cover. Other end spring bending sideways. Since screws carb are extended and this need to be pulled out straight, even taking cover half off can't get angle without bending spring.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #4

    Oct 10, 2013, 04:48 PM
    There are several other videos.
    Is the cable too tight?
    Carb may need to be removed.
    Can you separate or unhook the cable?
    These are generic answers, many are similar? Good Luck
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #5

    Oct 12, 2013, 06:19 PM
    Hi,
    Did not find an engine breakdown, but found the parts breakdown. It is at:
    http://www.arkansas-ope.com/GENERAC_GEN_IPL_01470-1
    Perhaps if you can get the numbers off the engine, I could help with that. Usually you take the air filter cover, air filter and the back of the air box off to access the carb and the fasteners that secure it.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Generac 7550exl won't start [ 3 Answers ]

Can't start generator by electric start or pull cord. Changed spark plug, charged battery, loosened nut on carburetor trying to drain, very little drainage. Fuel feed open , does not seem to be getting. Motor does not catch.

How to completely remove the program from the computer? [ 2 Answers ]

I uninstalled downloaded programs from the Uninstall Programs in the Control Panel. After I restore the system to the early date, I saw those removed programs show up again in the Uninstall Programs List but they just cannot locate the programs if I click on uninstall button. I believe the program...

Generac Engine Specs model052331 ser# 7078535 15 hp. On a generac exl8000 generator [ 1 Answers ]

I need to know the valve settings so I can put this engine back in use

View more questions Search