Ask Experts Questions for FREE Help !
Ask
    jodoncin's Avatar
    jodoncin Posts: 3, Reputation: 1
    New Member
    		  
    #1

    May 11, 2012, 07:23 AM
    Generac Engine Specs model052331 ser# 7078535 15 hp. On a generac exl8000 generator
    I need to know the valve settings so I can put this engine back in use
    jodoncin's Avatar
    jodoncin Posts: 3, Reputation: 1
    New Member
    		  
    #2

    May 11, 2012, 07:27 AM
    Where do I set the gap on the exhaust and intake valves as someone had removed and replaced the push rods and never finished the job
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Valve settings for 15 hp generac engine model 052331 ser#7078535 [ 1 Answers ]

This engine is on a generator exl8000

Generac generator [ 1 Answers ]

I have a generac generator svp5000 The engine runs but I can't get any current out of it I changed the brushes assembly but still can't get power what could be wrong?

Generac exl8000 repair [ 9 Answers ]

I just bought a Generac EXL8000 with a Briggs 15HP motor and 5.4 hours on the meter. The motor was only running at half throttle, and I could see that the governor spring had been relocated to keep the motor from revving too high. I thought it would be a simple adjustment. However, today I found...

Generac generator starting [ 1 Answers ]

My Generac generator will start but will only run for about 5 seconds and then it stalls. It won't start when I try again. If I try starting it again, it will again run for about 5 seconds and stall. I've owned it for about 9 years and have NEVER had a problem starting this before. I ran it for at...

Generac generator starting problems [ 1 Answers ]

My generator turns over constantly but won't start. What could be the problem?

View more questions Search