Ask Experts Questions for FREE Help !
Ask
    RichardCJ's Avatar
    RichardCJ Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 4, 2013, 02:55 PM
    Disassembled & cleaned my furnace Now I would like to see a diagram of correct assem
    I took my furnace apart to clean it. Replaced the "bulb", ceramic ignitor and reassembled. Before I fire it up I would like to see a diagram of the whole to make sure I did it right. Please help?
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Oct 4, 2013, 05:56 PM
    Hi Richard

    We need information to help. With that information, we can help, but once you have the required information you are probably better off just contacting the manufacturer directly so they can e-mail you a complete set of the installation/maintenance manual.

    Go down to your furnace and get the manufacturer's name, the name brand, the model #, and the serial number off the "rating plate" and then "google" the manufacturer.

    Once you find the manufacturer's website you can call them over at their customer service number and provide them with the model # and serial # for your furnace and they will help pretty fast off!

    You may also find the information readily available if you Google the manufacturer AND the model #... may be available as a downloadable PDF file!

    Let us know if you need help...

    Mark
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #3

    Oct 4, 2013, 06:33 PM
    We could probably give you 100 diagrams but they may not be for your heater. How about a brand and model?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Murray w/14hp B&S have cleaned the carb, and replaced fuel pump, won't continue running [ 1 Answers ]

As in the question

I have a CT-27SX12 and the color is not correct. Thecolrs are mainly pink & green & a [ 0 Answers ]

The color on my CT-27SX12 is mostly green with vertical streaks of pink. The adjustments; color, tint, sharpness do nothing. Is there anything I can do to correct it or are my tubes going bad. There is no magnetic interference at all.

Is this wiring diagram correct? 3 Lights, 1 Gang switch [ 3 Answers ]

Hi All, Hoping that someone out there can confirm that my wiring diagram will work (I am 99% sure). It is for my loft, will have 3 low energy bulbs (60w eqivilant). Operation is a simple 1 way Gang switch, cabling will be 2.5mm square, twin core & earth. Bulbs are in parallel. ...

I have disassembled the handle and cannot lift the spout from the base? [ 1 Answers ]

I have disassembled the handle and cannot lift the spout from the base? Do I need to disconnect anything from the bottom of the sink?

Reasonable cost to get the dryer vent cleaned & certified [ 0 Answers ]

In my townhome community, we are required to get our dryer vents inspected, cleaned and certified clean by a licensed company. What is a reasonable cost for this service? Who should we contact, an air duct cleaning company? Would they do this service? Also, the water collection pan underneath...

View more questions Search