Ask Experts Questions for FREE Help !
Ask
    clutz's Avatar
    clutz Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 4, 2007, 04:33 PM
    Nikki Carb - Return Spring Tension?
    Ok, so I have a small question here and looking for some advice.

    I am in the middle of a nikki 1bbl carb rebuild off a kohler CV25 OHV, and on the choke shaft end was a return spring coiled up around the shaft and I am wondering if there is any special tension or number of winds to use when reassembling the shaft

    If I understand it, I think the tension should just be right before a single wind, until the spring legs are in place?
    It's not like I have to wind it up a few times or something? Or do I?

    Hope I explained it right.

    THX:confused:
    newaukumdon's Avatar
    newaukumdon Posts: 525, Reputation: 44
    Senior Member
    		  
    #2

    Apr 4, 2007, 11:47 PM
    Nuts on, no if it fits put it there, I do not think you could get more winds on it.

    Don
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Friction and tension help please! [ 1 Answers ]

A 211 kg log is pulled up a ramp by means of a rope that is parallel to the surface of the ramp. The ramp is inclined at 30.0° with respect to the horizontal. The coefficient of kinetic friction between the log and the ramp is 0.850, and the log has an acceleration of 0.700 m/s2. Find the tension...

How much tension? [ 1 Answers ]

:) How much tension must a rope withstand if it is used to accelerate a 1046 kg car horizontally along a frictionless surface at 1.21 m/s2?

Tension of a rope [ 1 Answers ]

Two blocks are fastened to the ceiling of an elevator . The elevator accelerates upward at 1.60 m/s2. The blocks both have a mass of 12.5 kg. Find the tension in each rope.

Tension [ 1 Answers ]

A 38.6 kg sign is suspended by two wires, as the drawing shows. Find the tension in wire 1 and in wire 2. http://www.webassign.net/[email protected]/[email protected]

Nikki carb adjustments [ 1 Answers ]

Does anyone know how to adjust a Nikki carb on a kohler command ohv engine? I can't find any screws for this. Any help would be greatly appreciated. The engine will only run at full choke. I have ajusted the govenor.

View more questions Search